ReinfBarInclined Properties |
The ReinfBarInclined type exposes the following members.
Properties| Name | Description | |
|---|---|---|
 | AddBarOnBottom |
Add bar on Bottom - possible only for FullLength
|
| AddBarOnTop |
Add bar on top - possible only for FullLength
|
| Angle |
Angle between bar and master edge
|
| BottomLength |
Length of additional bar on the bottom
|
| Cover |
Cover of reinforcement
(Inherited from ReinforcementGroup.) |
| CoverFromSetting |
Use cover from DetailModelSetting
(Inherited from ReinforcementGroup.) |
| Diameter |
Diameter o reinforcement
(Inherited from ReinforcementGroup.) |
| DiameterOfMandrel |
Diameter of mandrel - multiplier of bar diameter to obtain inner diameter of bent reinforcement bars
(Inherited from ReinforcementGroup.) |
| EndsTypeBeg |
End type of the beginning of reinforcement bar
(Inherited from ReinforcementGroup.) |
| EndsTypeEnd |
End type of the end of reinforcement bar
(Inherited from ReinforcementGroup.) |
| Id |
Element Id
(Inherited from OpenElementId.) |
| InclinedReinfBarType |
Type of inclined reinf bar
|
| MasterComponent |
Master component of reinforcement
|
| MasterEdge |
Master edge of reinforcement - edge from which is measured angle
|
| MasterPoint |
Master point of reinforcement
|
| Material |
Material
(Inherited from Reinforcement.) |
| NumOfBarsInLayer |
Number of bars in layer
(Inherited from ReinforcementGroup.) |
| ReinfId |
Id representing reinforcement in Detail
(Inherited from Reinforcement.) |
| TopLength |
Length of additional bar on the top
|
See Also